lookiposter.blogg.se

Locker lock
Locker lock





locker lock
  1. Locker lock full#
  2. Locker lock code#

In order for your customers in wheelchairs to easily be able to open doors and gates, they must have a smooth surface that runs the full width of the door/gate on the push side. Consult your local AHJ for opening force requirements pertaining to fire-rated doors. This requirement does not apply to fire-rated doors. Here’s where one of those sticky exceptions comes into play. Note: this does not apply to the amount of force it takes to retract the bolt or to the initial amount of force that it takes to start opening the door. It should take no more than 5 pounds of continuous force to fully open a door or gate. If your door or gates utilizes spring hinges, it should take at least 1.5 seconds to close from 70° to 0°. If your door or gate has a door closer installed, it should be adjusted so that it takes at least 5 seconds for your door to close from 90° to 12°. It’s time to get out the protractor that you thought you’d never use past college. This advisory also dissuades the use of hardware that requires simultaneous hand and finger movements, such as keypads, but it does not state that this type of hardware is prohibited. To play it safe, do not use traditional door knobs – always use lever sets. This has been changed to an advisory in the 2010 code.

Locker lock code#

The 2003 code requires that any operable part have a shape that is easy to grasp with one hand without requiring tight grasping or twisting of the wrist to operate. There is one notable difference between the 2003 code and 2010 code. The most important aspect of this section is the mounting height for operable parts (pulls, handles, etc.) – they need to be a minimum of 34” and a maximum of 48” above the finished floor. Thresholds cannot be any higher than ½” and should be slip resistant. Clear width is measured from the face of the door to the stop when the door is fully opened at 90 degrees. In order for wheelchairs to have clear passage through your doors, at a minimum, your clear opening width must be 32” wide. ADA Codes for Doors and Locks Clear Opening Width (404.2.3) If you have any questions, contact your local Authority Having Jurisdiction (AHJ). It’s important to note that this is based on the 2010 code some jurisdictions are still operating under the 2003 code.

locker lock

There are so many numbers and exceptions that it’s enough to confuse even the veterans of our industry.Īllow me to shed light on some basic principles regarding ADA codes for doors and locks. Sure, you can look at the code book, but if you’re like most, poring over the Americans with Disabilities Act (ADA) codes will make you go cross-eyed – especially the door section. We regularly get asked about ADA codes for doors and locks.







Locker lock